•
Adjust the image using the "Auto"
function in OSD Main Controls.
•
Eliminate the vertical bars using the
Phase/Clock of Setup in OSD Main
Controls. It is valid only in VGA mode.
Image appears blurred, indistinct or too
dark
•
Adjust the contrast and brightness on
On-Screen Display.
An "after-image", "burn-in" or "ghost
image" remains after the power has been
turned off.
•
Uninterrupted display of still or static
images over an extended period may
cause "burn-in", also known as "after-
imaging" or "ghost imaging", on your
screen. "Burn-in", "after-imaging",
or "ghost imaging" is a well-
known phenomenon in LCD panel
technology. In most cases, the "burn-
in" or "after-imaging" or "ghost
imaging" will disappear gradually
over a period of time after the power
has been switched off.
•
Always activate a moving screen
saver program when you leave your
monitor unattended.
•
Always activate a periodic screen
refresh application if your LCD
monitor will display unchanging
static content.
•
Failure to activate a screen saver, or
a periodic screen refresh application
may result in severe "burn-in" or
"after-imaging" or "ghost imaging"
symptoms that will not disappear
and cannot be repaired. The damage
mentioned above is not covered
under your warranty.
Image appears distorted. Text is fuzzy or
blurred.
•
Set the PC's display resolution
to the same mode as monitor's
recommended screen native
resolution.
Green, red, blue, dark, and white dots
appears on the screen
•
The remaining dots are normal
characteristic of the liquid crystal
used in today's technology, Please
refer the pixel policy for more detail.
*
The "power on" light is too strong and
is disturbing
•
You can adjust "power on" light using
the power LED Setup in OSD main
Controls.
For further assistance, refer to the Service
contact information listed in Regulation &
Service Information Manual and contact
Philips customer service representative.
* Functionality different according to
display.
22