Husqvarna BMS 280P Operator's Manual page 20

Table of Contents

Available languages

3. If the hydraulic oil level is too low, it is necessary

to replace the hydraulic oil. Refer to

hydraulic oil and hydraulic oil filter on page 20 .

4. The hydraulic oil level must be filled to the middle in

the indicator.

To replace the hydraulic oil and hydraulic oil filter

WARNING:

to your skin. Clean spills with soap and

water.

WARNING:

hydraulic oil filters are dangerous to the

environment. Discard used chemicals at an

applicable disposal location.

Note:

It is faster to drain the hydraulic oil if the oil is

warm.

1. Stop the product on a level surface and remove the

ignition key.

2. Put a container below the hydraulic oil drain plug.

Refer to the label on the product where the oil drain

plug is located on your product.

3. Remove the hydraulic oil drain plug (A).

To replace the

Hydraulic oil is dangerous

Used hydraulic oil and

4. Remove the hydraulic oil filter cover.

5. Turn the hydraulic oil filter counterclockwise to

remove it.

6. Remove the hydraulic oil cap (B).

1998 - 001 - 03.07.2023

Table of Contents

Chapters

Table of Contents