5.2 PBX Settings for Inband Integration
•
Call Progress Tone Detection for Inband Mode
Specifies whether to detect "Call Progress Tone".
5.2.3
PBX Interface Parameters
The following items can be programmed using KX-TVM/NCV Maintenance Console under "System
Parameters" by selecting the "Parameters" tab.
PBX Environment
•
PBX Type
Specifies the type of PBX which is connected to the VPS.
•
Integration Mode
Select "Inband". If PBX type is set to the Panasonic KX-T series, the Inband Signalling
parameters are set automatically and should not be altered.
SEQUENCE CODES
•
Maximum Extension Number Length
Specifies the maximum number of digits that the connected PBX recognises as an extension
number.
•
Extension Number of VPS Port
Specifies the extension number for each VPS port on the connected PBX.
Note
•
Extension numbers of the VPS ports will automatically be assigned when the PBX type has
been changed.
•
Operator Transfer Sequence
Tells the VPS how to transfer a call to the operator.
Example: FTX [hookswitch flash
•
Extension Transfer Sequence
Tells the VPS how to transfer a call to an extension.
Example: FTX [hookswitch flash
•
Alternate Extension Transfer Sequence
Tells the VPS how to transfer a call to an extension that belongs to the "Alternate Extension
Group". This is useful for extensions that need a special transfer procedure (i.e., blind transfer)
158
Installation Manual
D
Disconnect
F
Hookswitch Flash
R
Ring Detection
T
Dial Tone Detection
X
Dial Extension
,
Dialling Pause (default 1 s)
;
Dialling Pause (default 3 s)
DTMF Tones
0-9,
, #
dial tone
dial (operator) extn.]
dial tone
dial extn.]