Ftp Client; Debug Mode Via Web Server - Siemens SIMATIC S7-1500 Manual
Hide thumbs
Also See for SIMATIC S7-1500:
- System manual (523 pages) ,
- Function manual (402 pages) ,
- Manual (188 pages)
Table of Contents
Advertisement
Wiring
4.1 Terminal assignments and interface descriptions
Required parameter settings
When assigning parameters of the GigE Vision camera, ensure that a value of at least 10,000
is entered for the parameter "Packet Delay" (SCPDx). Lower values may result in an overload
of the Ethernet port.
More information
You can find the list with an overview of the supported cameras and the recommended
parameter settings ("Packet Delay", "MTU Size", "Frame Rate", "Resolution", etc.) on the Inter
net (https://support.industry.siemens.com/cs/ww/en/view/109815405).
4.1.4.2
FTP client
You establish a connection to an external FTP server via the Ethernet interface with the
integrated FTP client, for example, to
• archive individual images of the connected camera.
• read in data such as neural networks.
The FTP client is enabled in the configuration in HW Config and configured in the
configuration file "ftpclient.conf" (Page 57).
NOTE
Note that data transferred via FTP is not buffered in the module. If an interruption, such as a
cable break, power supply dip, etc., occurs during the data transfer, data may be lost.
4.1.4.3
Debug mode via web server
With the help of the web server of the TM NPU, the outputs of the user program
(MicroPython script) can be read out and displayed for debugging purposes.
Prepare your system for this as described below:
1. Create a configuration file: debug.conf (Page 59).
2. Copy the configuration file to the SIMATIC Memory Card.
3. Enable debug mode in HW Config.
NOTE
Debug mode is only intended for commissioning. For security reasons, disable debug mode
after commissioning is complete.
Also remove the configuration file "debug.conf", if present, from the SIMATIC Memory Card
to prevent debug mode from being enabled (again) without permission.
More information
You can find more information on the debug messages and debug mode in section Viewing
MicroPython debug messages via web server (Page 43) and in the module-specific security
instructions (Page 8).
22
Technology Module TM NPU
Equipment Manual, 07/2023, A5E46384784-AC
Advertisement
Table of Contents
