Table of Contents
Advertisement
2.3
Inverter Split Type
COOL mode
Room
17°C - 32°C
Temperature
Outdoor
0°C - 50°C
Temperature
Table 2.
FOR OUTDOOR UNITS WITH AUXILIARY ELECTRIC HEATER
When outside temperature is below 0°C, we strongly recommend
keeping the unit plugged in at all times to ensure smooth ongoing
performance.
To further optimize the performance of your unit, do the following:
• Keep doors and windows closed.
• Limit energy usage by using TIMER ON and TIMER OFF functions.
• Do not block air inlets or outlets.
• Regularly inspect and clean air filters.
For a detailed explanation of each function, refer to the Remote Control
Manual.
2.4
Other Features
• Auto-Restart
If the unit loses power, it will automatically restart with the prior
settings once power has been restored.
• Refrigerant Leakage Detection
The indoor unit will automatically display "EC" when the unit detects
refrigerant leakage.
• Louver Angle Memory
When turning on your unit, the louver will automatically resume its
former angle.
For a detailed explanation of your unit's advanced functionality (such
as TURBO mode and its self-cleaning functions), refer to the Remote
Control Manual.
NOTE ON ILLUSTRATIONS
Illustrations in this manual are for explanatory purposes. The actual
shape of your indoor unit may differ. The actual shape shall prevail.
Setting vertical angle of air flow
While the unit is on, use the SWING/DIRECT button to set the direction
(vertical angle) of airflow.
1. Press the SWING/DIRECT button once to activate the louver. Each
time you press the button, it will adjust the louver by 6°. Press the
button until the direction you prefer is reached.
2. To make the louver swing up and down continuously, press and hold
the SWING/DIRECT button for 3 seconds. Press it again to stop the
automatic function.
Setting horizontal angle of air flow
The horizontal angle of the airflow must be set manually. Grip the
deflector rod (See Fig. 3) and manually adjust it to your preferred
direction.
Climate 5000 – 6720886922 (2019/12)
HEAT mode
DRY mode
0°C - 30°C
10°C - 32°C
-15°C - 30°C
0°C - 50°C
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set louver at too vertical an
angle for long periods of time. This can cause water to condense on the
louver blade, which will drop on your floor or furnishings. (See Fig. 2)
When using COOL or HEAT mode, setting the louver at too vertical an
angle can reduce the performance of the unit due to restricted air flow.
Do not move the louver by hand. This will cause it to become out of sync.
If this occurs, turn off the unit and unplug it for a few seconds, then
restart the unit. This will reset the louver.
CAUTION
Do not keep louver at too vertical an angle for long periods of time. This
can cause water condensation to drip on your furnishings.
Fig. 2.
CAUTION
Do not put your fingers in or near the blower and suction side of the unit.
The high-speed fan inside the unit may cause injury.
Deflector rod
Fig. 3.
Sleep Operation
The SLEEP function is used to decrease energy use while you sleep (and
does not need the same temperature settings to stay comfortable). This
function can only be activated via remote control.
Unit Specifications and Features
5
Advertisement
Table of Contents
