Siemens RUGGEDCOM RX1501 Installation Manual page 47

Hide thumbs Also See for RUGGEDCOM RX1501:

Table of Contents

RUGGEDCOM RX1501

Installation Guide

Disconnect the power supply wiring from the terminal block. Alternatively, for convenience, remove the

terminal block with the wiring still connected and set it aside to be connected later to the new module.

Install a new or blank module to prevent the ingress of dust and dirt.

Installing a Power Module

To install a power module, do the following:

If equipped, remove the existing module.

If applicable, connect the supplied terminal block to the module or connect the terminal block from the

previous module.

Confirm or connect the wiring from the power supply to the module. For more information, refer to

Section 2.5, "Connecting

Insert the module into the empty slot.

Figure 25: Installing a Power Module

1. Chassis 2. Power Module 3. Screws

Hand-tighten the screws to secure the power module to the chassis.

Turn on power to the device and confirm the module is receiving and supplying power. This is indicated by

the LEDs on the module.

LED

Installing/Removing Power Modules

Power".

State

Green

The module is supplying power

The module is receiving power

Description

Chapter 4

Modules

Table of Contents