Table of Contents
Advertisement
Figure 16 Management interface ports on rear panel - models 3080 and 3090
Item
1
2
3
RS-232 serial management port
The server has one RS-232 connection port, located on the rear panel of the server. This
serial port is intended to be used during system setup. The serial port is not intended as
a permanent management connection. This port should not be used as the primary
management interface for the server. The primary management interface to the server is
through the NAS Manager or through server's command line interface (CLI), which can
be accessed through the network.
Any VT100 terminal emulation interface can be used to access to the CLI so that you can
perform management or configuration functions. Connect the terminal to the serial port
on the rear panel of the server, then set the host settings to the values shown in the
following table to ensure proper communication between the terminal and the server.
Terminal
Connection
Emulation
Baud rate
Data bits
Stop bits
Hitachi NAS Platform 3080 and 3090 G2 Hardware Reference
Serial management port (RS-232 DB-9 connector)
Ethernet management port 0 for customer facing management (RJ45
connector)
Ethernet management port 1 for private management (RJ45 connector)
Table 17 Host setting values
Crossover (null modem) cable
VT100
115,200 Bps
8
1
Chapter 5: Hitachi NAS Platform server components
RS-232 serial management port
Description
Requirement
49
Advertisement
Table of Contents
