TeamPoS 3000 XT
7.3.6.
Replacing the Hard Drive
Caution: Be sure to observe all ESD precautions and power off procedures.
To replace the hard drive:
1. Remove the AC cord from the back of the
terminal.
2. Remove the chassis top cover and pc
shield. (See section 7.3.1 and Figure 7-1.)
3. Unplug the data and power cable from the
hard drive.
4. Remove the retaining screw.
5. Slide the hard drive bracket up and out of
the chassis.
6. Remove the four screws that secure the
hard drive to the bracket.
7. Replace the hard drive and secure it to the
bracket with the four screws.
8. Slide the hard drive bracket into place in
the chassis and seat it securely.
9. Secure it with the retaining screw.
10. Connect the two cables.
11. Replace the pc shield and chassis top cover.
7-12
Installation and Maintenance Manual
Disconnect two
cables
Remove retaining
screw
Remove four screws
D900000172