Husqvarna AUTOMOWER 420 Operator's Manual page 18
Hide thumbs
Also See for AUTOMOWER 420:
- Technical manual (104 pages) ,
- Operator's manual (100 pages) ,
- Workshop manual (60 pages)
Table of Contents
Advertisement
B
A
•
Put the boundary wire around the secondary area
(B) to make an island. Refer to
on page 17 .
Note:
The boundary wire must be put as 1 loop
around all of the work area (A + B).
Note:
When the product cuts grass in the
secondary area, the
be selected. Refer to
34 .
3.4.4 To examine where to put the guide
wire
•
Put the guide wire in a line at a minimum of 2 m /
6.5 ft. in front of the charging station.
•
Make as much free area as possible to the left of
the guide wire when facing the charging station.
Corridor width on page 29 .
Refer to
•
Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
•
Do not make sharp bends when you install the
guide wire.
135º
•
If the work area has a slope, put the guide wire
diagonally across the slope.
18 - Installation
To make an island
Secondary area mode must
Secondary area on page
90º
135º
3.4.5 Work area examples
•
If the charging station is put in a small area (A),
make sure that the distance to the boundary wire
is at a minimum 3 m / 10 ft. in front of the charging
station.
•
If the work area has a passage (B) with no
guide wire installed, the recommended minimum
distance between the boundary wires is 2 m / 6.5
ft. With a guide wire installed through the passage,
the recommended minimum distance between the
boundary wires is 60 cm / 24 in.
•
If the work area has areas which are connected by
a narrow passage (B), you can set the product to
first follow and then leave the guide wire after a
certain distance (C). The settings can be changed
Lawn Coverage on page 27 .
in
•
Use the GPS Assisted Navigation that helps the
product select the most optimal operation. Refer to
To set the GPS Assisted Navigation on page 27 .
•
If the work area includes a secondary area (D),
To make a secondary area on page 17 .
refer to
Put the product in the secondary area and select
Secondary area mode .
1201 - 007 - 20.02.2023
Advertisement
Table of Contents
