Printing The Configuration Pages - Canon imagePASS-R1 Service Manual

Table of Contents

16. Make sure that the imagePASS power switch is in the ON (|) position, and power on the imagePASS (see

imagePASS" on page

17. Power on the printer using the main power switch.

Allow the imagePASS to start up and reach Idle (00 should appear on the imagePASS LED display).

NOTE:

If you press the Fiery icon on the printer touch panel before the imagePASS finishes the startup process, "TCP connect error"

appears on the printer touch panel. Press OK to return to the Home screen, and wait until the imagePASS reaches Idle.

Wait approximately 15 minutes longer for the imagePASS to start up and print Start page.

18. If you saved a configuration file earlier, restore the system configuration (see

on page

49).

NOTE:

If it was not possible to save a configuration file or if you installed an upgraded version of system software, you must configure

Setup using the Configuration pages you printed earlier. For information about performing Setup, see Configuration and Setup,

which is part of the user documentation set. Bypass any settings if it is more appropriate for the site administrator to set them.

After you exit Setup and allow the system to reboot, ask the site administrator to restore the custom files that were archived earlier.

19. Install any required software patches:

• If you reinstalled the same version of system software, be sure to reinstall all software patches that were previously

installed on the imagePASS. For a list of installed patches, see the Configuration pages that you printed earlier.

• If you installed an upgraded version of system software (for example, version 1.0 to version 2.0), contact your authorized

service/support center for a list of valid software patches. Some or all of the patches listed on the Configuration pages

that you printed earlier may no longer be valid. Before installing a patch, be sure to verify with your authorized service/

support center that it is valid for your system version. Installing an invalid patch may result in system corruption.

20. Reconnect any USB devices that you may have removed earlier.

21. If the imagePASS requires a static IP address (for example, in a non-DHCP network environment), work with the

network administrator to configure it (see the Configuration and Setup which is part of the user documentation).