Table of Contents
Advertisement
Commissioning
7.1
Measures prior to commissioning
Before commissioning the system, check that it is properly installed and connected. The
drive system must be commissioned as described in the operating instructions for the
converter/inverter.
Note
This list below does not claim to be complete. It may be necessary to perform additional
checks and tests in accordance with the specific, on-site situation.
Thermal hazard: hot surfaces
The surface temperature of the motors can exceed 100°C.
Do not touch hot surfaces.
If necessary, implement shock-hazard protection measures.
Temperature-sensitive parts (electric cables, electronic components) must not be placed on
hot surfaces.
Mechanical connection
● All touch protection measures for moving and live parts have been taken.
● The motor has been assembled and aligned properly.
● The rotor can spin unhindered.
● The operating conditions correspond to the data specified on the rating plate.
● All fixing screws, connecting elements, and electrical connections must be tightened and
● The output elements have the proper setting conditions according to type, for example.
Synchronous/induction motors 1PH813
Operating Instructions, 04/2009, 610.48000.22
CAUTION
properly implemented.
– Couplings are aligned and balanced.
– The belt tension is properly adjusted if a belt drive is used.
– Gear tooth flank play and gear tooth tip play as well as radial play are properly
adjusted if a gearwheel drive is used.
7
51
Advertisement
Table of Contents
