Installing The Dp-Cl21P/Dp-Cl21M Software; (For Windows) - Panasonic WORKIO DP-CL21 Setup Manual
Color laser printer
Hide thumbs
Also See for WORKIO DP-CL21:
- Network manual (169 pages) ,
- User manual (300 pages) ,
- Maintenance and specifications (103 pages)
Table of Contents
Advertisement
Setup
5
Place media with the print side up under the hooks
in the tray.
Hook
NOTE:
• Coated Paper, Transparencies or Envelopes can be
loaded in the multi-purpose tray. See "About Media" of
"Setting and Printing" in the Operating Instructions.
• Most media has instructions recommending the side to
be printed first.
• Do not mix different types or thickness of media in the
media tray at one time; this may cause a jam.
• Loading media exceeding the designated sheets may
cause a media jam or shifting of print.
6
Confirm the media guides are adjusted to the media
size.
7
Slide the media tray completely into the slot.
CAUTION
• Be sure to hold the media tray with both hands so that
you do not drop it. The media tray weighs approximately
6.4 kg (14 lbs.) when it is fully loaded.
8
Pull (1) and raise (2) the paper support so that the
media does not drop from the output tray.
Paper support
16
Fill media up
to here.
Load media with
print side up.
1
2
Installing the DP-CL21P/
DP-CL21M Software
(For Windows)
There are two methods of installing printer software for
Windows, Automated Printer Setup and Custom
Printer Setup. This Setup Guide only explains the
Automated Printer Setup. If you want to use the
Custom Printer Setup, refer to Network section of the
Operating Instructions.
Printer Software
PCL 5c Printer Driver
PS Printer Driver
LPR Port Monitor
Status Display
HDD Utility
(It is installed when a
hard disk drive is
installed in the printer.)
Print Media Test
1
Pattern*
Operating Instructions
!
: It is automatically installed.
*
1
It can be installed using the Custom Printer Setup.
When using the Network Interface Cable:
The following are the steps to set up LPR Port printing
using TCP/IP.
Step 1: Setting up TCP/IP on the computer
Step 2: Setting up TCP/IP on the printer
Step 3: Installing the printer driver and utilities
Step 1: Setting up TCP/IP on the computer
If the TCP/IP protocol is already installed on your
computer and it is configured, proceed to the next step. If
it is not installed, you need to install TCP/IP in the
operating system on the computer and configure it.
If the administrator manages the IP Address, contact him/
her to confirm the values before setting up. Be sure to
assign the unique value for the IP Address that is not
used on another device on the network. Regarding the
configuration of TCP/IP, refer to the help menu or
documentation for Windows.
Automated Printer Setup
DP-CL21P
DP-CL21M
!
!
!
–
!
!
!
!
!
!
–
–
!
!
Advertisement
Table of Contents
