Video Intercom System Door Station Installation and Operation Guide VL-GC002A Model No. Thank you for purchasing a Panasonic Door Station. Please read this Installation and Operation Guide before using the unit and save for future reference.
Important Information Important Information FCC and Other Information ... 2 Important safety instructions ... 3 Additional safety information ... 4 For best performance ... 4 Introduction and Installation Included items ... 5 Location of controls ... 6 Before installation ... 7 Installing the door station ...
The lightning flash with arrow head within a triangle is intended to tell the user that parts inside the product are a risk of electric shock to persons. Important safety instructions 1) Read these instructions. All the safety and operating instructions should be read before the appliance is operated.
Important Information Additional safety information 1. Use only the power source marked on the unit. If you are not sure of the type of power supplied to your home, consult your dealer or local power company. 2. Use only the specified AC adaptor. 3.
Included items • The Mounting base comes preattached to the Door station. Item Door station Mounting base Wood screws Button cover Introduction and Installation Quantity 4 mm x 20 mm ( Notes ------ ------ ″ x ″ ) ------...
Introduction and Installation Location of controls Front view Camera • When a visitor presses the Call Button, the camera will turn on and an image of the visitor will be shown on the display of the monitor station and sub monitor station. •...
Before installation To avoid malfunction or communication disturbance, do not install the door station in the following locations: – Places where vibration or any other kind of impact occurs. – Places where echoing is frequent. – Places where a high concentration of dust, hydrogen sulfide, phosphorus, ammonia, sulfur, carbon, acid, or noxious fumes occur.
Introduction and Installation Installing the door station Loosen the mounting screw, and then remove the mounting base. Install the mounting base to a wall using the attached wood screws. (4 mm x 20 mm, Wall Important information: On the bottom surface of the door station, there are holes to allow water to drain. Do not cover it up when installing.
Page 9
Remove the adjustment cover, and then adjust the angle of the camera lens. Screwdriver Adjustment cover * Be sure to install the adjustment cover after adjusting the angle of the camera lens. Standard installation height and filming range Adjust the angle of the camera lens when carrying out installation. •...
Page 10
Introduction and Installation Attach the wire to the terminal. Wall Connect to terminals D11 and D12 (D21 and D22) of the monitor station. Secure the door station to the mounting base. • Tighten the mounting screws. Tighten with screws Wire (Not included) Mounting base Wall Door station (rear)
Page 11
Attach the button cover. • Align the inside of the button cover base with the bottom of the call button, and then push the top of the button cover to fit it into place. Button cover I Removing the button cover •...
Help Cleaning Clean the unit with a soft, dry cloth when cleaning. For excessive dirt, wipe the unit with a slightly damp cloth. Important information: • Do not use anything containing alcohol, polish powder, powder soap, benzine, thinner, wax, petroleum, or boiling water. Also do not spray with insecticide, glass cleaner, or hair spray.
Technical data about this product Standby: Approximately 5 V DC (2 mA) Power supply *1: At operation: Approximately 20 V DC (190 mA) Approximately height 130 mm x width 98 mm x depth 43 mm Dimensions: Approximately 300 g (0.7 lb.) Mass (Weight): –10 °C to 50 °C (14 °F –...
Page 16
00985, U.S.A. Copyright: • This material is copyrighted by Panasonic Communications Co., Ltd., and may be reproduced for internal use only. All other reproduction, in whole or in part, is prohibited without the written consent of Panasonic Communications Co., Ltd.