Installing The Auto Take-Up Reel Unit - Epson Stylus Pro 11880 Unpacking And Setup Manual
Professional 64-inch printer
Hide thumbs
Also See for Stylus Pro 11880:
- User manual (182 pages) ,
- Network manual (46 pages) ,
- Limited warranty (12 pages)
Table of Contents
Advertisement
Installing the Auto Take-Up Reel
Unit
Checking the contents
Make sure that all the items shown below are
included and not damaged.
Drive unit
Flange (for drive unit)
Reflector
Take-up reel core (3 inch)
Cable clamps (2)
6
Movable unit
Flange (for movable unit)
Movable unit stopper
Screws
(Large 2 [black], small 4)
Drafting tape
Installing the Auto Take-up Reel Unit
1. Attach the drive unit on the horizontal strut as
shown below, and tighten the black screws to
attach the drive unit to the printer securely.
2. Attach the flange (marked with R) on the drive
unit by pinching the knob.
The flange is reversible. One side is for the
3-inch core, and the other side is for the 2-inch
core. Set the appropriate side for the core.
3. Attach the clamps on the right base unit, and
route the cord through the clamps.
Advertisement
Table of Contents
