Pvt Disassembly - Polaris RZR 900 2017 Service Manual

Hide thumbs Also See for RZR 900 2017:

Table of Contents

PVT DISASSEMBLY

1. RZR S 1000 / RZR 4 900 ONLY: Loosen the outer

cover intake hose clamp and remove hose from PVT

2. Remove the eight screws

3. Remove the PVT intake and exhaust ducts by

loosening the clamps

inner clutch cover.

retaining the outer clutch

retaining the ducts to the

4. Remove the drive belt. (see Chapter 5 – Belt

Removal (EBS) page 6.10)

5. Remove the Driven Clutch retaining bolt

Do not strike the driven clutch to free it from the

transmission input shaft. This will damage the clutch.

For MY16 EBS models, if the driven clutch will not

disengage, a commercially found 2–Jaw puller may be

used. Only pull from inside the slider pockets. Pulling

on the sheaves may cause damage to the clutch.

6. Remove the Drive Clutch retaining bolt

7. Remove the seven fasteners retaining the inner

clutch cover to the engine and transmission.

8. Remove the inner clutch cover from the vehicle.

9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual

Table of Contents