2. Total harmonic distortion is measured by the digital spectrum analyzer. Music Center : SA-HT40P-S System : SC-HT40P-S Front Speaker : SB-PF40P-S Surround Speaker : SB-PS40P-S Center Speaker : SB-PC40P-S Subwoofer : SB-W40P-S Music Center : SA-HT40PC-S System : SC-HT40PC-S...
Page 3
“ATTENTION SERVICER” Some chassis components may have sharp edges. Be careful when disassembling and servicing. 1. This section describes procedures for checking the operation of the major printed circuit boards and replacing the main components. 2. For reassembly after operation checks or replacement, reverse the respective procedures.
Page 4
1.2. Disassembly of Front Panel Assembly Step 1: Remove 4 screws from the Rear Cabinet Assembly. Step 2: Insert an Allen key into the top hole of the Rear Cabinet Assembly and push the Front Panel...
Page 5
Assembly as arrow shown. 1.3. Disassembly of Woofer Follow (step 1) to (step 2) of Item 1.2. Step 1: Detach the (+) white and (-) blue wires from the Woofer. Step 2: Remove 4 screws from the Woofer. 1.4. Disassembly of Network Assembly Follow (step 1) to (step 2) of Item 1.2.
Page 6
Step 1: Remove glue from Cord Bush. Step 2: Remove Cord Bush by pushing out with the Allen key.
Step 3: Hold the Rear Cabinet Assembly and remove the Network Assembly as arrow shown. 2. Connection of the Speaker Cables - Be sure to connect speaker cables before connecting the AC power supply cord. - The load impedance of any speaker used with this unit must be 4 - Be sure to connect the cable from the right speaker to the right terminal and the cable from the left speaker to the left terminal.
Page 8
- To prevent damage to circuitry, never short-circuit positive (+) and negative (-) speaker wires. - Be sure to connect only positive (white) wires to positive (+) terminals and negative (blue) wires to negative (-) terminals. Incorrect connection can damage the speakers. Positioning for best effect How you set up your speakers can affect the bass and the sound field.
corner can increase the apparent output level, but can result in unnatural bass. 3. Connection of Wiring Diagram 4. Exploded view 4.1. Cabinet Parts Location...
Page 10
4.2. Packaging Note: The diagram below shows the packaging for SB-FSC40P-S.
SB-FSC40P-S consists of SB-PF40P-S (x2), SB-PS40P-S (x2) & SB-PC40P-S (x1). 5. Replacement Parts List Notes : - Important safety notice : When replacing any of these components, be sure to use only manufacturer’s specified parts shown in the parts list.