Advertisement
OEM/Integrators Installation Guide
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable configurations with
respect to Part 2.1093 and different antenna configurations
4. F r FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify compliance
as a composite system. When testing the host device for compliance with Part15 Subpart B, the host
manufacturer is required to show compliance with Part 15 Subpart B while the transmitter module(s) are
installed and operating. The modules should be transmitting and the evaluation should confirm that the
module's intentional emissions are compliant (i.e. fundamental and out of band emissions).
The host manufacturer must verify that there are no additional unintentional emissions other than what is
permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) Only antennas of the equal or less gains as 1.35dBi may be used with this module
When using an antenna higher than the gain mentioned above, the conducted oputput power must be reduced,
and the product may require C2PC filing with additional tests and RF exposure evaluation.
In the event that these conditions cannot be met (for example higher than max gain or co-location with another
transmitter), then the FCC/IC authorization is no longer considered valid and the FCC ID/IC ID cannot be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC/IC authorization.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user's manual of the end product which integrates this module. The end user
manual shall include all required regulatory information/warning as show in this manual.
Advertisement
