Inspecting The Verticutter; Installing The Transport Rollers - Toro Reelmaster 5010-H Series Operator's Manual
Verticutter, cutting unit with 5–inch or 7–inch reel
Hide thumbs
Also See for Reelmaster 5010-H Series:
- Diagnostic manual (476 pages) ,
- Service manual (335 pages) ,
- Operator's manual (128 pages)
Table of Contents
Advertisement
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: Whenever the verticutter has to be tipped to expose
the verticutter blades, use the kickstand (supplied with
traction unit); refer to
Figure
1. Kickstand
1
Inspecting the Verticutter
Parts needed for this procedure:
1
Verticutter
Procedure
After the verticutter is removed from the box, inspect the
following:
1. Check each end of the reel for grease. Grease should be
visibly evident in the internal splines of the reel shaft.
2. Ensure that all nuts and bolts are securely tightened.
3. Make sure that the carrier frame suspension operates
freely and does not bind when moved back and forth.
2.
Figure 2
2
Installing the Transport Rollers
Parts needed for this procedure:
2
Transport roller assembly
2
Cotter pin
Procedure
Secure a transport roller bracket to each side plate pin with
a cotter pin
(Figure
3).
1. Cotter pin
Note: The roller should be positioned to the rear of the
verticutter.
6
Figure 3
2. Transport roller assembly
Advertisement
Table of Contents
