Ce Marking; Compliance With The European Low Voltage Directive; Compliance With The European Emc Directive; Definitions - ABB ACSM1 Hardware Manual
Regen supply modules
Hide thumbs
Also See for ACSM1:
- Manual (510 pages) ,
- Firmware manual (448 pages) ,
- Hardware manual (112 pages)
Table of Contents
Advertisement
78
CE marking
A CE mark is attached to the regen supply module to verify that the regen supply module follows the
provisions of the European Low Voltage and EMC Directives (Directive 73/23/EEC, as amended by 93/
68/EEC, and Directive 89/336/EEC, as amended by 2004/108EC).
Compliance with the European Low Voltage Directive
The compliance with the European Low Voltage Directive has been verified according to standards
EN 50178, EN 61800-5-1 and EN 60204-1.
Compliance with the European EMC Directive
The cabinet builder is in responsible for the compliance of the drive system with the European EMC
Directive. For information on items to consider, see:
•
Subsections
(2004), category
•
The chapter
•
Technical Guide No. 3 – EMC Compliant Installation and Configuration for a Power Drive System
(3AFE61348280 [English]).
Definitions
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic equipment to
operate without problems within an electromagnetic environment. Likewise, the equipment must not
disturb or interfere with any other product or system within its locality.
First environment includes domestic premises. It also includes establishments directly connected
without intermediate transformers to a low-voltage network which supplies buildings used for domestic
purposes.
Second environment includes all establishments other than those directly connected to a low-voltage
network which supplies buildings used for domestic purposes.
Drive of category C2. Power drive system with rated voltage less than 1000 V which is neither a plug-in
device nor a movable device and, when used in the first environment, is intended to be installed and
commissioned only by a professional.
Drive of category C3. Power drive system with rated voltage less than 1000 V, intended for use in the
second environment and not intended for use in the first environment.
Drive of category C4. Power drive system with rated voltage equal to or above 1000 V, or rated current
equal to or above 400 A, or intended for use in complex systems in the second environment.
Compliance with EN 61800-3 (2004), category C2
The regen supply module meets the requirements of the EMC Directive with the following provisions:
1. The regen supply module is equipped with a WFU-xx regen filter module of the correct type.
2. The motor and control cables are selected as specified in the chapter Planning the electrical
installation in the ACSM1-04 Drives Hardware Manual (3AFE68797543 [English]).
3. The supply cable, DC cable and control cables are selected as specified in the chapter
electrical
4. The regen supply module and regen filter module are installed according to the instructions given in
this manual, and the drive(s) have been installed according to instructions given in their respective
hardware manual.
5. The regen supply module, regen filter module and drive(s) are installed on the same conductive back
wall.
6. The regen supply module is used as a supply unit for motor ACSM1-04 drive(s), frame sizes A...D.
Technical data
Compliance with EN 61800-3 (2004), category
C3; and
Compliance with EN 61800-3 (2004), category C4
Planning the electrical installation
installation.
C2;
Compliance with EN 61800-3
in this manual
below
Planning the
Advertisement
Table of Contents
