Low-voltage alert
If the voltage of the main power supply goes below 4.8 V, the system will activate
a 'Low-voltage alert'. When using the safe, you will be reminded with a voice
prompt 'Low voltage, please replace battery'. Once having this alert, please
replace batteries in time.
Attention:
low-voltage may affect the normal use of the safe. Please replace batteries in
time when receiving low-voltage alert.
Wall-mount instructions
As shown in Figure 7, select an appropriate installation position, open the safe
door and take out the plugs on the back panel. Mark hole positions on the wall
or cabinet and drill holes for expansion tubes. Put expansion tubes in the holes,
attach the safe and �x it with screws.
11
Attention
1.
Concrete wall is recommended for mounting the safe.
2.
For safety reasons, please make sure the safe is �rmly attached to the wall.
Rear side of the safe
Expansion screw
Wall
Figure 7
12