Miele PG 8581 Supplementary Document page 21
Washer disinfector
Hide thumbs
Also See for PG 8581:
- Operating instructions manual (144 pages) ,
- Operating instructions manual (144 pages) ,
- Operating instructions manual (136 pages)
Table of Contents
Advertisement
Advisory code
Fault 440
Spray arms:
Fault 460 - top
Fault 461 - middle
Fault 462 - bottom
Fault 518 (For DOS1)
Fault 519 (For DOS3)
Fault 526
MUW216743-2
Cause and remedy
The float switch in the sump of the machine has not been activated. The switch may be
blocked.
Remove the filter combination.
Check the float switch to make sure it moves freely. The float switch is located in the sump of
the machine behind the spray arm
The programme has been cancelled because of a blocked spray arm.
Arrange the load so that the spray arms can turn easily.
Clean cabinet and filters if dirty and gritty. Abrasive pastes should not be processed in this
machine.
Foaming can cause these Advisory codes. Check that instruments have been rinsed before
loading into the washer disinfector. Chemical residues may cause foaming. To clean foam
from the washer disinfector, remove the majority using a container and then run one or
more rinse cycles.
No flow was detected when dispensing from an external supply container.
For all chemicals, the safety instructions given in the manufacturer's safety
Check the level of the container and refill or replace it as necessary.
Check the suction apertures of the siphons and remove any deposits.
Check the hose connections on the siphons, the machine and any DOS modules.
Remove any kinks from the dispensing hoses and check the hoses for leaks. Position the
dispensing hoses so they cannot kink.
Vent the dispensing system.
If you identify any leaks in the dispensing hoses or defects on the siphons, contact Eschmann.
Minimum flow pressure was not reached because one or more free water connections in the
back panel of the wash cabinet is not properly secured.
Check the washers in the water connectors in the back panel of the wash cabinet and
remove any blockages.
Foaming can cause this Advisory code. Check that instruments have been rinsed before
loading into the washer disinfector. Chemical residues may cause foaming. To clean foam
from the washer disinfector, remove the majority using a container and then run one or
more rinse cycles.
- CAUTION
Handling of chemicals
data must be observed.
21
- Quick Links:
- Process Related Faults and Messages
Hide quick links:
Advertisement
Table of Contents
