Table of Contents
Advertisement
Set up using arp/ping commands
You can change the printer's IP address by changing the ARP table (table of IP address and MAC
addresses) managed by the OS on the setting computer.
Check that the setting computer is connected to the network in the same segment as the printer, and
that the arp+ping IP setting for the UB-E04 is set to Enable. (The factory default is Enable.)
You can check the UB-E04 settings on the status sheet.
1
Delete the IP address you want to set to the printer from the ARP table.
arp -d (IP address)
E.g.) arp -d 192.168.0.10
2
Add the printer's MAC address and the IP address you want to set to the ARP table.
arp -s (IP address) (MAC address)
E.g.) arp -s 192.168.0.10 00-26-AB-7B-00-00
3
Execute the ping command and enable settings.
ping (IP address you want to set)
E.g.) ping 192.168.0.10
When a message like "Reply From 192.168.0.10: Bytes=32 Time < 10ms TTL=255" is displayed, the IP
address setting is complete.
Use EpsonNet Config or EpsonNet Config (Web version) for settings other than the IP address.
Chapter 2 Set up
2
21
Advertisement
Table of Contents
