Summary of Contents for Philips PerfectCare 8000 Series
Page 1
PerfectCare 8000 Series EN User manual ZH-S 用户手册 Please read this instruction carefully before using the appliance. 使用产品前请仔细阅读本使用说明书。 Please keep this instruction book for future reference. 保留备用。...
- If the mains cord or the steam supply hose is damaged, you EASY DE-CALC knob. If steam continues to escape, switch off must have it replaced by Philips; a service centre authorized by the appliance and contact the service center authorized by Philips or similarly qualified persons in order to avoid a hazard.
Page 5
Electromagnetic fields (EMF) surface. When you place the iron on its stand, make sure that This Philips appliance complies with all applicable standards and the surface on which you place it is stable. Stand is the heel of regulations regarding exposure to electromagnetic fields.
Filling water tank Water tank empty light 给水箱注水 水箱无水指示灯 Warning 警告 www.philips.com/support...
Page 10
Preparing for use 使用准备 ~2 分钟 Steam 30 seconds horizontally before ironing to prevent water leaking. ZH-S 为了防止漏水的可能性,开始熨烫之前请水平熨烫 30 秒。 www.philips.com/support...
Page 11
Auto-off 自动关熄功能 关机 ~4分钟 Figure 3: It switches off automatically when not in use for 10 minutes. ZH-S 图 3:停止使用10分钟后,熨烫机会 ~10分钟 自动关机。 Vertical ironing OptimalTEMP Warning 智能温控科技 垂直熨烫 警告 www.philips.com/support...
Page 13
Auto mode 自动模式 Figure 2: Steam comes out when you move, steam stops when you stop moving or lift up the iron. ZH-S 图 2:在您移动熨烫机时蒸汽会喷出,在您停止移 动或抬起熨烫机时蒸汽会停止。 www.philips.com/support...
Page 14
Vertical mode 自动竖喷模式 秒 This mode will be deactivated if the iron is not used for 15 seconds. ZH-S 如果在 15 秒内未使用熨烫机,此模式将会自动关闭。 www.philips.com/support...
Trouble shooting 故障排除 If you have any problems, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Center in your country. Problem Cause Solution The ironing board cover Steam has condensed on the ironing Replace the ironing board cover if the foam material has worn out.
Page 20
If you prefer to use the automatic steam mode or speed mode, is off. ensure that the light indicator for the mode is lighted up on top of the handle, and thereafter move your Philips Steam Generator Iron to have steam. The appliance has switched off.