Advertisement
Available languages
Available languages
Quick Links
1
DEH40228 - Installation Instructions
PowerMark Plus™ Load Centers
100–225 Ampere Single- and Three-Phase 10–42 Circuit
Indoor Type
:
WARNING
Hazard of electrical shock or burn. Turn
off power before working inside this equipment.
General
To comply with the Canadian Electrical Code and the
Canadian Standards Association, the load center must be
installed in accordance with the information included on
the label on the inside of the equipment. This must also
be done in accordance with the applicable local electrical
codes and by a qualified electrical contractor or licensed
electrician.
Installation
1. Remove Front
Slip the front and the accessory package back into the
carton to protect the finish.
2. Remove Service Entrance Barrier (Main Breaker only)
Back out and save the two mounting screws securing the
service entrance barrier over the main breaker
connections, then lift the barrier up and out.
Barrier
Mounting
Screws
3. Remove Interior (Optional)
Back out the mounting screws and save them for reuse.
Mounting
Screws
4. Mount Box
Flush mount: Line up the front box edge with the finish
wall surface and screw or nail to the stud through the
small knockouts in the box side.
Surface mount: Screw or nail through the keyhole
slots in the back of the box.
5. Remove Knockouts for All Main and Branch Circuits
First knock the center knockout inward. The outer rings
should be alternately pried up or driven in one at a time.
6. Pull Incoming Service and Branch Circuit Wiring into
Box
7. Replace Interior
Drive in the mounting screws loosened in step 2.
Advertisement
Related Manuals for GE PowerMark Plus DEH40228
Summary of Contents for GE PowerMark Plus DEH40228
- Page 1 DEH40228 - Installation Instructions PowerMark Plus™ Load Centers 100–225 Ampere Single- and Three-Phase 10–42 Circuit Indoor Type WARNING Hazard of electrical shock or burn. Turn 3. Remove Interior (Optional) off power before working inside this equipment. Back out the mounting screws and save them for reuse. General To comply with the Canadian Electrical Code and the Canadian Standards Association, the load center must be...
- Page 2 Use GE circuit breakers only. For troubleshooting or service related questions, https://electrification.us.abb.com/products/load- centers — ABB Inc. 305 Gregson Drive Cary, NC 27511 GE is a registered trademark used under license from General Electric company...
- Page 3 DEH40228 - Instructions d’Installation Panneaux de Distribution PowerMark Plus™ 10 à 42 Circuits à phase simple et triple de 100-225 A Type pour l’intérieur 3. Enlever l’interieur (facultatif) WARNING Hazard of electrical shock or burn. Turn Retirer les vis de montage et les conserver pour les off power before working inside this equipment.
- Page 4 à l’intérieur. Vous référer à centers l‘étiquette sur le disjoncteur pour un couple de serrage approprié. N’utiliser que des disjoncteurs GE. — ABB Inc. 305 Gregson Drive Cary, NC 27511 GE is a registered trademark used under license from General Electric company...