Software Procedures
n
SW 003 (C, 2C) Matrox Video Board Driver Installation
Section 1: Introduction
This job card describes how to install the driver for the Matrox G450 video board for the C, 2C, or 18"
flat panel (1x or 2x) monitor.
Section 2: Items Required
u
Centricity RA600 Tools CD-ROM
u
One or two C monitor(s) or 18" flat panel .
Section 3: Prerequisites
u
OS is loaded.
u
Video boards are properly installed in the workstation.
u
Video cables are properly connected.
u
Monitors connected and powered on.
Section 4: Procedure
1.
Locate and launch the Setup.exe program for the Matrox_G450. The program should be
located at C: > Drivers > Matrox_G450 > Setup.exe.
SW 003 (C, 2C) Matrox Video Board Driver Installation
Page 188