Table of Contents
Advertisement
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER
(Enable as suffix) by scanning the appropriate bar code in the section
"Label ID Control"
options if multiple identification features are enabled.
3. Scan a bar code to select the symbology for which you wish to configure a
custom Label ID from the section
page
4. Determine the desired character(s) (you may choose up to three) which will
represent the Label ID for the selected symbology.
5. Turn to the
and find the equivalent hex digits associated with your choice of Label ID.
For example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D. Turn to
page 281
mined. For the example given, the characters '3' and 'D' would be
scanned. More examples of Label ID settings are provided in
NOTE
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 6. Label ID Position Options
246
on page 39. Reference Figure 6 for Label ID positioning
40.
ASCII Chart on page 295
and scan the bar codes representing the hex characters deter-
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again at
the beginning.
Prefix
Label ID
Aim ID
OR
Label ID Symbology Selection, starting on
on the inside back cover of this manual
Bar Code Data
Label ID
Suffix
Keypad, starting on
Table
14.
Programming Reference Guide
Advertisement
Table of Contents
