Table of Contents
Advertisement
The maximum frequency for an ARB waveform is 2.5kHz (2 vectors of O.2ms each).
As you increase the number of vectors in a waveform, the frequency of the waveform
decreases.
FREQ
where O.2ms
In an extreme case, if you build a waveform with 150 vectors and set each vector to
the maximum vector length of 127 with .t1 t set to 19
for the waveform is 2.6mHz (381 seconds).
19.99ms .. (127 .. 150)
Insert Vector. The Insert Vector
a vector is inserted
- the vector is inserted immediately after the current vector (the current vector is
pointed to by the Vector Marker and intensified by the
- the inserted vector has V HGT
- the vectors following the inserted vector are renumbered.
-
the Vector Marker is incremented by
If the Vector Marker is pointing to the last vector,
Invert Function. Invert Function inverts the output signal with respect to the SYNC out-
put. The DC Offset is not affected.
Mode.
The only modes allowed in ARB are Free Run and Gate.
- Free Run outputs a continuous signal. All triggers are ignored.
- Gate outputs
threshold conditions. The output gates off after the trigger level changer
waveform is completed.
ARB
=
19.99ms
381 seconds (6
=
function
adds one vector to the current ARB wave. When
:
a
continuous signal while the trigger level satisfies the slope
(cent)
1
+ ..
2
.99ms,
.3
minutes).
=
=
0
V LEN
1.
t
1
and points to the inserted vector.
a
new Vector 1 is
47b
n )
the minimum frequency
Z
Axis output).
inserted.
Advertisement
Table of Contents
