Cisco AS5400XM Quick Start Manual page 44
Universal gateways
Hide thumbs
Also See for AS5400XM:
- Installation manual (104 pages) ,
- Regulatory compliance and safety information manual (68 pages) ,
- Installing manual (16 pages)
Table of Contents
Advertisement
Use the enable command and password to enter privileged EXEC mode. You are in privileged EXEC mode when the
Step 1
prompt changes to
Gateway> enable
Password: password
Gateway#
Enter global configuration mode. You are in global configuration mode when the prompt changes to
Step 2
Gateway# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Gateway(config)#
Enter controller configuration mode to configure your T3 controller for slot 1 port 0. Slot values range from 1 to 7.
Step 3
The port number is always 0.
Gateway(config)# controller t3 1/0
Gateway(config-controller)#
Enter the telco framing type, either c-bit or m23:
Step 4
Gateway(config-controller)# framing c-bit
Enter your clock source, either internal or line:
Step 5
Gateway(config-controller)# clock source line
Step 6
Enter your cable length. Values range in feet from 0 to 450.
Gateway(config-controller)# cablelength 450
Configure your T1 controllers. The range is 1 to 28.
Step 7
• To configure all 28 T1 controllers at once, enter:
Gateway(config-controller)# t1 1-28 controller
• To omit specified T1 controllers while configuring others, specify them as needed. In this instance, T1 controllers
11–14, 21, 22, and 24–28 are not configured.
Gateway(config-controller)# t1 1-10,15-20,23 controller
Return to privileged EXEC mode:
Step 8
Gateway(config-controller)# Ctrl-Z
Gateway#
To save the gateway configuration, save it to NVRAM. See the "Saving Configuration Changes" section on page 60.
Tip
Verifying Channelized T3 Controller Operation
To verify that your controller is up and running and that no alarms have been reported, enter the show controller command and
specify the controller type, slot, and port numbers:
Gateway# show controller t3 1/0
T3 1/0 is up.
Applique type is Channelized T3
No alarms detected.
MDL transmission is disabled
FEAC code received:No code is being received
Framing is C-BIT Parity, Line Code is B3ZS, Clock Source is Internal
Data in current interval (270 seconds elapsed):
0 Line Code Violations, 0 P-bit Coding Violation
44
.
Gateway#
.
Gateway(config)#
Advertisement
Table of Contents
