HP j6700 Installation Manual page 7

Fire gl-ux graphics card and software

Hide thumbs Also See for j6700:

Table of Contents

Figure 0-4

Removing the I/O Card Retainer

3. Locate the card you want to remove and, using the T-15 Torx driver, remove the I/O card's

bulkhead screw as shown below:.

Figure 0-5

Removing the I/O Card

4. Pull evenly on the outside edges of the I/O card to remove it.

To install a card into your system unit, follow these steps.

1. Locate the appropriate slot for the I/O card that is to be installed.

2. Insert the card into the slot you have chosen with the bulkhead appropriately positioned. See

above. The non-bulkhead end of the card should be placed in the card guide. Press ﬁrmly and

evenly on the card until it is seated in the connector. Screw the T-15 Torx screw into the card's

bulkhead (using 6 inch-pounds of torque) to secure the card.

3. Replace the card retainer by placing the bottom retainer hook in the slot on the air divider and

the clips on the PULL tabs into their slots on the chassis wall.

Close the left side panel of the system unit by following the procedure in the User's

refer to your workstation documentation for instructions on using the HP-UX System Administra-

tion Manager (SAM) utility to verify your graphics conﬁguration

I/O Card Retainer

I/O Card

Bulkhead

Screw

I/O Card

Bulkhead

I/O Card

Air Divider

I/O Card Being Removed

Guide.

Also

Table of Contents

C3750 - workstation Workstation c3650 A7789a C3700 - workstation