Table of Contents
Advertisement
Configuring the Access Controller xl Module
18
Maximum number of client VLANs have been configured.
Operation failed.
The maximum number of client VLANs for this configuration has been
reached. An existing client VLAN must be removed before the
requested VLAN can be added.
Changing the VLAN-Base
When the ACM is installed in the 5300xl switch, a VLAN is created for the
internal downlink port (<slot-id>DP). By default, this client VLAN is VLAN ID
2000, the vlan-base. You may change this using the following command.
HPswitch (Config)# access-controller vlan-base <2-4094>
where <2-4094> is the starting VLAN ID (VID) used when a client VLAN is
configured.
The vlan-base is used by the [no] access-controller <slot-id> client-ports [ether-
net] < port-list > command when it configures client VLANs for the specified
switch ports. The very first port specified for use as a downlink client port
becomes an untagged member of the vlan-base VID. Subsequent downlink
client ports are assigned as untagged members of the next available sequential
VID, beginning at the vlan-base.
Configuring Client VLANs
You may configure a client VLAN with a specific VID, containing just the
downlink port as a tagged member. Later, you can add an untagged 5300xl port
as a downlink client port to carry client traffic.
Use the following command to configure a client VLAN:
HPswitch (Config)# access-controller <slot-id> client-ports vlan <vlan-list>
where <slot-id> is the slot letter where the module is installed.
<vlan-list> is the VID for the desired client VLAN.
Configuring Uplink Network Ports
Uplink network ports are any switch ports that are members of the uplink
VLAN, that is, the VLAN where the ACM's internal uplink port is an untagged
member. By default, the uplink port (<slot-id>UP) is an untagged member of
the DEFAULT-VLAN on the 5300xl switch. In this default configuration, all
members of the DEFAULT-VLAN are uplink network ports.
Advertisement
Table of Contents
