Contents 1 Important Safety Notice 2 Your Docking Speaker Introduction What's in the box Overview of the main unit 3 Get started Connect power Turn on 4 Play Play audio from iPod/ iPhone/ iPad Play through an audio cable Other features Update the firmware 5 Product information Specifications...
1 Important Warning • Never remove the casing of this apparatus. • Never lubricate any part of this apparatus. • Never place this apparatus on other electrical equipment. • Keep this apparatus away from direct sunlight, naked Safety flames or heat. •...
Page 5
The making of unauthorized copies of copy- protected material, including computer programs, files, broadcasts and sound recordings, may be an infringement of copyrights and constitute a criminal offence. This equipment should not be used for such purposes. “Made for iPod, ” “Made for iPhone, ” and “Made for iPad”...
2 Your Docking Overview of the main unit Speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the docking speaker, you can: • enjoy audio from your iPod/iPhone/iPad;...
Page 7
h Display panel • Adjust volume. j Toggle switch for lightning/30-pin control • Adjust brightness of display and bottom light.
3 Get started Turn on In standby mode, the docking speaker turns on Always follow the instructions in this chapter in automatically when it detects an audio signal sequence. from docked iPod/iPhone/iPad. Switch to standby mode Connect power The docking speaker switches to standby mode in the following situations: Caution In dock mode: no audio signal from the...
4 Play Switch the dock Switch the dock between the lightning connector and 30-pin connector for different generation of Apple device. Slide the switch to the right. Play audio from iPod/ iPhone/ » The dock swivels and the alternate iPad connector is accessible.
When using the docking speakerfor the Listen to the iPod/ iPhone/ iPad first time, a required software application automatically pops up. Note • Make sure that the iPod/ iPhone/ iPad is loaded correctly. • Start music play in your iPod/ iPhone/ iPad. »...
B: If no iPod/iPhone/iPad is docked, you can set Charge your mobile phone time manually. Charge your mobile phone through the USB In standby mode, press TIME/DATE to socket in the docking speaker with a USB cable display [--:--]. (not supplied). Press and hold TIME/DATE for 2 seconds to activate time setting.
Adjust brightness • Press repeatedly to select different levels of display light. • Press and hold to turn on or off the bottom light. 3 sec Follow onscreen instructions to complete firmware updating. Note • During the firmware updating, keep the iPod/ iPhone/ iPad powered on and docked on the docking speaker.
5 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 2.5 W RMS Signal to Noise Ratio > 55 dBA MP3 Link Input 650m V RMS Amplifier Speaker Impedance 4 ohm Speaker Driver 1.5''...
If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips.com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available.