Advertisement
Available languages
Available languages
DRYER INSTALLATION
Remove pedestal,installation hardware, and
instructions from the shipping carton.
Insert the T-clip of the 4 retainers into the dryer base
as shown. Press up on the back of the clip and pull
outward to lock into place.
Position dryer on top of the pedestal.
NOTE
Because of the weight of the dryer, two or more people
may be needed.
NOTE
If dryer was previously installed, uninstall it as follows:
A. Uninstalling an electric dryer:
1) Unplug the power supply cord,
2) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.
B. Uninstalling a gas dryer:
1) Unplug power supply cord.
2) Turn off the gas supply.
3) Pull the dryer away from the wall enough to loosen
the vent clamp. Loosen the clamp and carefully
remove the exhaust vent from the dryer exhaust
outlet.
T-clip
Retainer
for washer/
combo
for dryer
for dryer
for washer/
combo
4
Make sure the holes on the pedestal align with the
holes in the appliance, then install 2 screws at each
corner to securely attach the appliance to the
pedestal.
NOTE
If the screws are not installed properly, noise and
vibration may result.
Move the dryer to the desired place.
NOTE
The appliance and pedestal assembly must be placed
on a solid and level floor for proper operation. Adjust
the legs of the appliance and pedestal by turning with
a wrench. Then, adjust the lock unt toward the
pedestal while holding the pedestal leg using a
wrench.
Higher
Adjustable
feet
Lock
nut
Adjustable
feet
Lower
Adjustable
feet
Advertisement
