ENGLISH (Original instructions)
1-1. Pointer
1-2. Stopper
1-3. Adjusting screw
1-4. Rubber spike
2-1. Lock lever
2-2. Angle guide
2-3. Knob
2-4. Scale
2-5. Pointer
2-6. Tighten
2-7. Loosen
3-1. Knob
3-2. Down
3-3. Up
3-4. Center of blade thickness
4-1. Fence
SPECIFICATIONS
Max. grooving depth
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting crescent shaped slots for
the placement of flat wooden dowels or biscuit by a
plunging action.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
4-2. Lock lever
4-3. Angle scale
4-4. Tighten
4-5. Loosen
5-1. Lock lever
5-2. Pointer
5-3. Angle scale
5-4. Center of blade thickness
5-5. Blade cover
6-1. Lock lever
6-2. Pointer
6-3. Angle scale
6-4. Set plate
6-5. Thickness of set plate
6-6. Center of blade thickness
6-7. Blade cover
Model
Type of blade
Plate joiner blade
-1
No load speed (min
)
Overall length
Net weight
Safety class
) : 86 dB(A)
pA
) : 97 dB(A)
WA
ENE013-1
Vibration
The
vibration
determined according to EN60745:
Work mode : cutting grooves in MDF
ENF002-2
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENG905-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
4
7-1. Set plate
8-1. Slide switch
9-1. Lock nut
9-2. Plate joiner blade
9-3. Inner flange
9-4. Clamp screw
9-5. Blade cover
9-6. Loosen
9-7. Tighten
9-8. Shaft lock
10-1. Dust bag
10-2. Fastener
10-3. Dust nozzle
25-1. Exhaust vent
25-2. Inhalation vent
PJ7000
Plate joiner
20 mm
11,000
302 mm
2.5 kg
/II
total
value
(tri-axial
2
) : 2.5 m/s
or less
h
2
ENG900-1
vector
sum)
ENG901-1