8.2 Replenishing the makeup
(1) Overview
●Replenish the makeup in the makeup reservoir within 60 minutes after a makeup Low warning was
generated. If replenishment is not performed, the printer will stop.
●The makeup can be replenished without regard as to whether the IJ printer power is ON or OFF or the
printer's operating state.
●When the makeup is replenished, the warning is automatically reset.
(2) Operation
Open the maintenance cover, pull the makeup reservoir forward, and remove the
1
cap of the makeup reservoir.
●Hold the reservoir and pull it forward.
●When moving the reservoir, move it gently.
Remove the cap from the makeup bottle and replenish the ink by pouring it into
2
Cap
Makeup bottle
●Gradually add the makeup to avoid spilling. Also, exercise care to avoid excessive replenishment.
●If the mesh filter inside the cap is soiled, take it out and clean it
If makeup is accidentally spilt, wipe it up promptly with wiping paper or some-
thing similar. In addition, do not close the maintenance cover until you are sure
that the wiped portion has completely dried.
3
Close the makeup reservoir cap.
●Tighten the cap securely. The solvent component may evaporate.
4
Return the reservoir base to its original position.
5
Close the maintenance cover.
8-3 ●Replenishing the makeup
Makeup reservoir
Maintenance cover
Pull out.
the makeup reservoir.
CAUTION
Makeup
reservoir
Cap