Table of Contents
Advertisement
4 - 16 Workabout Pro4 (Windows Embedded Hand-Held 6.5) User Manual
The drop-down menu at the top of the Device tab allows you to limit the scope of the scan to a particular type
of device. If, for example, you choose Computer from this menu, only computers within range of the Workabout
Pro4 are listed in the Device tab. Choosing All lists all detected devices.
Pairing a Device
If you intend to pair a device (a headset, for example), power the device on and bring it within 10 meters of the
Workabout Pro4 before proceeding with the discovery process described below.
To pair devices:
•
Follow the manufacturer's instructions to place the remote device in pairing mode.
•
Choose the Devices tab and Scan for devices in your area.
•
When the scan is complete, tap on the device to which you want to pair.
•
In the pop-up menu, choose Pair.
An authentication dialog box is displayed.
•
If the remote device has authentication enabled, type the PIN in this dialog box.
•
To proceed without authentication, tap on Next.
NOTE
If a remote device has authentication enabled and you've skipped the authentication
process, a pop-up screen will ask if you want to allow the remote device to connect to
the Workabout Pro4. Tap on Yes and type the PIN. When authentication is complete,
tap on Done.
After entering the device PIN, the Services dialog appears with a list of services available for that device.
Draft #6
Advertisement
Table of Contents
