Table of Contents
Advertisement
Initial Configuration and Operation
Note:
When a connection to a certain access point is made, you may
not use the 'Edit, ' 'Delete, ' and 'Connect' buttons. To use these
functionalities, disconnect from the AP first.
>
You may use an access point you would like to use by
pressing [Add] button to add a new access point.
>
To change the information on the added access point,
press [Edit] to change.
>
To delete an added access point, select the target access
point and press [Remove].
Note:
• Due to the nature of a Wi-Fi network, signal interruption
may be feared at 2.4GHZ when the device is connected
through a wireless LAN network.
• Depending on the number of the wireless devices that are
sharing the hub to which the camera is connected or the
hubs using the same or adjacent channels, the network
speed might become slower.
48
• As there are possibilities of the video feed being
interrupted due to the network problem when used under
a wireless network environment, it is recommended that
the stream settings of the audio and video are set to
default settings.
IP Address status
>
Automatically set with DHCP: Click on this radio button
to use DHCP to automatically configure the network
settings of the device through a DHCP server.
>
Statically set: Manually set the network configurations.
-
IP Address: Input the IP address
-
Subnet Mask: Input the subnet mask address.
-
Gateway: Input the gateway address.
-
Primary DNS Server: Input the address of the Main
DNS Server.
-
Secondary DNS Server: Input the address of the
secondary DNS server.
• Save: Press this button to save the changes you made.
Advertisement
Table of Contents
