Table of Contents
Advertisement
DOK-SUPPL*-VAK*X0.1***-IT01-EN-P
Rexroth IndraControl VAK 10.1, VAK 40.1 Drawer Keyboard
Loss of degree of protection IP 65!
The housing in which the drawer keyboard is installed, has to fulfill the fol‐
lowing conditions:
● free from impurities
● sufficient mechanical strength and flatness
These criteria influence the required degree of protection IP to a great ex‐
tent.
Further required measures are to be taken depending on the mounting lo‐
cation, e. g. the stabilization of the mounting frame.
1. Create a mounting cut-out with 8 holes, diameter 4.5 mm, according to the illus‐
trations "Mounting cut-out" on the following pages.
2. Remove the paper strip from the seal on the rear side of the front panel.
3. Insert the drawer keyboard from the front into the cut-out. The mounting bolts M4
are inserted into the drilled holes, see
13.
4. Fasten the display by screwing the nuts at the rear side of the mounting bolts, see
fig. 10-4 "Mounting of the device " on page
NOTICE
Tighten the screws and nuts with the corresponding torque according to the following
table.
Threads
M4
Fig.10-1: Tightening torques
Mechanic damage due to wrong mounting torque.
Mounting torques
1.4 Nm
fig. 10-4 "Mounting of the device " on page
13.
Bosch Rexroth AG
Mounting
11/21
Advertisement
Table of Contents
