Table of Contents
Advertisement
Notes regarding installation
The standards and directives applicable
in your country must be observed
during planning, set-up, operation and
maintenance.
A 230 volt alternating current power supply
is required for this product (there must be a
phase and neutral conductor).
The product is only intended for fixed
installation in in-wall switch boxes with
a minimum depth of 50 mm and a screw
distance of 60 mm (in accordance with DIN
49073-1) in indoor areas.
When connecting the device terminals,
ensure that permitted wires and wire cross
sections are used.
The consumers connected to the relay
outputs must have sufficient insulation.
Observe the technical data, in particular
the maximum permissible switching power
of the relay and the type of consumers to be
connected, before connecting a consumer
(see technical data at the end of these
instructions). The device should only be
loaded to the specified power limit.
Overloading may result in destruction of the
device, fire or an electric shock.
Advertisement
Table of Contents
