Table of Contents
Advertisement
5
Removal and replacement procedures for
authorized service provider parts
This chapter provides removal and replacement procedures for authorized service provider parts.
IMPORTANT:
provider. Accessing these parts can damage the computer or void the warranty.
NOTE:
Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer.
Component replacement procedures
To remove and replace computer components, use these procedures.
NOTE:
HP continually improves and changes product parts. For complete and current information about
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
You must remove, replace, or loosen as many as 46 screws when you service the parts described in this
chapter. Make special note of each screw size and location during removal and replacement.
Preparation for disassembly
To remove and replace computer components, use these procedures.
See
Removal and replacement procedures preliminary requirements on page 21
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
Kickstand
To remove the kickstand, use these procedures and illustrations.
Table 5-1
Kickstand description and part number
Description
Kickstand
Before removing the kickstand, follow these steps:
Prepare the computer for disassembly (see
▲
Remove the kickstand:
Lift the kickstand off the computer. The kickstand is held to the computer with magnets.
▲
Components described in this chapter should be accessed only by an authorized service
Preparation for disassembly on page
for initial safety procedures.
Spare part number
M93494-001
29).
29
Advertisement
Table of Contents
