Advertisement
Replacement of the air filter
1) Turn off the power and remove the power plug from the outlet.
When turning off the power, make sure to follow the procedures of "Powering off the projector" described in
the operating instructions of the projector.
2)
Pull out the air filter unit.
Use a Phillips screwdriver to turn the screws counterclockwise until they turn freely, and then remove the
unit.
3) Remove the holder.
Loosen the three screws on the holder (A, B), slide the holder in the direction shown by the arrow in the
image, and lift up to remove the holder.
4)
Remove the air filter.
Hook your fingers in the slot to lift up and remove the air filter.
5)
Attach the new air filter.
Inserting the new air filter by slowly sliding it will make it easier to attach.
The side with the sponge must be the top. Attaching it with the wrong side up or forcing it to attach will
cause the air to leak in. The air filter does not work fully and as a result, dust will get into the projector.
6) Attach the holder.
Place the holder (A, B) on top of the filter.
Slide the holder so that its arrows line up with the arrows on the unit, and attach the holder.
Tighten the three holder screws.
7)
Attach the air filter unit to the projector.
Perform step 2) in the reverse order.
8) Connect the power plug to the outlet, turn on the power, and then perform [Filter
counter reset].
For details, refer to "Resetting the value of [Filter counter]" (
1-
ENGLISH
Screw
Holder B
Screw
Holder A
.
page ENGLISH-2).
Advertisement
