Service And Repairs; Verify Interlock System Operation - Toro Greensmaster 3200 Service Manual
Hide thumbs
Also See for Greensmaster 3200:
- Operator's manual (44 pages) ,
- Installation instructions manual (24 pages) ,
- Installation instructions (2 pages)
Advertisement
Service and Repairs
NOTE: See the Perkins 100 Series Workshop Manual
or Briggs and Stratton Vanguard 3/LC Repair Manual for
more component repair information.
Verify Interlock System Operation
CAUTION
The interlock switches are for the opera-
tor's protection; do not disconnect them.
Check the operation of the interlock
switches daily for proper operation. Re-
place any malfunctioning switches be-
fore operating the machine.
The purposes of the interlock switches are as follows: to
prevent the engine from cranking or starting unless the
Functional Control Lever is in NEUTRAL, to prevent op-
erating the traction pedal with Functional Control Lever
is in NEUTRAL, and Also, shut off the engine if the oper-
ator leaves the seat without the Functional Control Le-
ver in NEUTRAL. Also, the reels will shut off if the
Functional Control Lever is moved to NEUTRAL or
TRANSPORT.
Greensmaster 3200/3200–D
1. Sit on the seat, engage parking brake, and move
Functional Control Lever to NEUTRAL. Try to depress
traction pedal. If the pedal does not depress, the inter-
lock system is operating correctly. Correct problem if not
operating properly.
2. Sit on the seat, engage parking brake, keep traction
pedal in neutral, and place Functional Control Lever in
MOW or TRANSPORT. Try to start the engine. If the en-
gine does not crank, the interlock system is operating
correctly. Correct problem if not operating properly.
3. Sit on the seat and start engine. Move Functional
Control Lever to Mow. Raise off the seat. If the engine
stops, the interlock system is operating correctly. Cor-
rect problem if not operating properly.
4. Sit on the seat, engage parking brake, keep traction
pedal in neutral, and place Functional Control Lever in
NEUTRAL. Start the engine. Move Raise / Lower – Mow
Control Lever forward to lower the cutting units. If the
units do not start rotating, the interlock system is operat-
ing correctly. Correct problem if not operating properly.
Rev. C
Page 6 – 43
Electrical System
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Chapters
Troubleshooting
