Installation; Safety Instructions For Installation - Miele ProLine CS 1013-1 Operating And Installation Instructions
Hide thumbs
Also See for ProLine CS 1013-1:
- Operating and installation instructions (60 pages) ,
- Operating and installation instructions (48 pages) ,
- Operating and installation instructions (56 pages)
Table of Contents
Advertisement
Safety instructions for installation
Risk of damage from incorrect connection.
Incorrect installation can cause damage to the ProLine element.
The ProLine element must only be installed by a qualified person.
Damage from falling objects.
Take care not to damage the ProLine element when fitting wall units or a cooker
hood above it.
Fit the wall units and the cooker hood before the ProLine element.
The room in which the ProLine element is installed must conform
to all relevant local and national building and safety regulations.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.
A deep fat fryer must not be installed directly next to a gas hob or
a wok burner as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288 mm between these
two appliances.
The ProLine element must not be installed over a fridge, fridge-
freezer, freezer, dishwasher, washing machine, washer-dryer or
tumble dryer.
When installing the ProLine element, make sure that the gas pipe
and mains connection cable cannot come into contact with hot
appliance parts.
The mains connection cable and any flexible gas connection pipes
must be installed in such a way so that they do not come into
contact with any moving kitchen parts (e.g. a drawer) after the
ProLine element has been installed, and that they cannot be
subjected to any mechanical action which could cause damage.
Observe carefully the safety clearances listed on the following
pages.
Installation
33
Advertisement
Table of Contents
