ISSUE 2.0
Level:
SA
Description
Use Program 22-11 : DID Translation Table to specify for each Translation Table entry (1000).
• The digits received by the system (eight maximum)
• The extension the system dials after translation (36 digits maximum)
• The name that should show on the dialed extension display when it rings (12 characters maximum)
• The Transfer Target - 1 and 2
If the Transfer Targets are busy or receive no answer, those calls are transferred to the final transfer
destination (Program 22-10).
• Operation Mode
Use the following chart when entering and editing text for names. Press the key once for the first
character, twice for the second character, etc. For example, to enter a C, press 2 three times.
When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
Clear/Back or DND (2W Digital/IP Multi-
line Terminal)
Flash
Input Data
Conversion Table Number
Programming Manual
Program 22 : Incoming Call Setup
22-11 : DID Translation Table
Key for Entering Names
Enter characters: 1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters: 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right ar-
row soft key instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
1 ~ 1000
SL2100
Program
22
2-297