Table of Contents
Advertisement
Argument
boot-device
boot-file
boot-flags
Using the Boot Manager to Install Nokia IPSO
Use the install command to install Nokia IPSO. The syntax of the command
is:
install
For complete installation procedures, see the appropriate version of release
notes.
Note
Using the install command to perform a full installation deletes the
existing IPSO image on the IP1200 Series.
To install a new copy of the Nokia IPSO kernel
1. At the boot manager command prompt, enter:
2. Enter the information the install command requests (your system IP
3. Reboot the IP1200 Series.
Nokia IP1200 Series Security Platform Installation Guide
Default
wd0
(the hard disk drive)
/image/current/kernel
-x
BOOTMGR[0]>install
If you used the passwd command to protect this command with a
password, see
"Protecting the Boot Manager with a Password"
108, the boot manager prompts you for your password before allowing
you to execute the install command.
address, the server IP address, and other information).
Using the Boot Manager to Install Nokia IPSO
on page
107
Advertisement
Table of Contents
