Table of Contents
Advertisement
2-2. Replacement of Hard Disk Drive
Installation
n
Pay special attention to the work mentioned in the
following so that no shock is applied to hard disk
drive.
4. Attachment of CN-1667/1668 boards
(1) Connect the CN-1667/1668 boards to the
hard disk drive.
n
Align to pin 1 side of each connector when
connecting the CN-1668 board.
(2) Fix the harness with tape.
n
When the new tape is used, cut the Scotch
electrical tape, flame-resistant film No.10 (or
equivalent) in 2.5 cm, and use it.
5. Attachment of hard disk drive
(1) Connect the harness to the connector of hard
disk drive.
(2) Place the HDD unit gently on the hard disk
drive and match the location of screw holes.
n
Carry out this work carefully so that the HDD
unit doesn't hit the hard disk drive.
(3) Fix the hard disk drive to HDD unit with the
four unify screws.
Tightening torque: 98 x 10
{10kgf.cm}
(4) Connect the harness to the connector on the
hard disk drive (8P).
2-12 (E)
_2
N.m
Hard disk drive
B6-32 (UNC)
HDD unit
Hard disk drive
Connector (8P)
CN-1668 board
B-side
J2 connector
(pin 1 side)
Tape
Harness
Harness
B6-32 (UNC)
Harness
BKNW-116
Advertisement
Table of Contents
