Table of Contents
Advertisement
Chapter 1: Overview
Management Interfaces
The Access Point supports the full range of management interfaces via the
IntelliVue Smart-hopping Access Point Controller (APC). These interfaces also
enable you to view the status of the Access Point including the following
information:
• System configuration such as firmware version
• Connection information such as numbers of packets received and transmitted,
and number of errors
• Wave data information such as total number of seconds of data sent and lost
The AP statistics can be read by remote devices (e.g., an IntelliVue Database
Server), using the Scaleable Node Address Protocol (SNAP).
The following status items can be displayed using the APC web interface:
• AP Name
• Physical Address
• Partnered AP Controller
• IP Address
• Subnet Mask
• Default Gateway
• AP Type
Connectors and Status Indicators (ITS4834D)
Figure 1-3 shows the ITS4843D and Figure 1-4 shows the ITS4843B/C controls and
connectors on the 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna
Ethernet Interface to
IntelliVue Smart-hopping
Ferrule Cable Connector
to IntelliVue Smart-hopping
Figure 1-3: ITS4843D 1.4 GHz IntelliVue Smart-hopping Core AP and Remote Antenna
1-6
Link LED
Activity LED
Power/Sync, Radio,
and Network
Status LEDs
Sync Unit
Core Access Point
IntelliVue Smart-
hopping Core Access
Point
RA 2
RA 1
Serial Port
IntelliVue Smart-hopping
Remote Antenna
Power LED
(Yellow)
Controls and Connectors
Ferrule Cable Connectors
to Remote Antennas (2 & 1)
RA 2
RA 1
Fiber Cable Connectors
to Remote Antennas (2 & 1)
with RA Status LEDs
Fiber Cable Connector
to IntelliVue Smart-hopping
Core AP
Connection LED
(Green)
Advertisement
Table of Contents
Troubleshooting
