Hitachi CP-X2520 Service Manual page 33
Multimedia lcd projector
Hide thumbs
Also See for CP-X2520:
- User manual (124 pages) ,
- Brochure (3 pages) ,
- Technical specifications (2 pages)
Table of Contents
Advertisement
Wiring of power supply block 1
(1) Connect power units
(2) Wire CNBAR and CNLAP, and place FE1
(3) Wire CNPW, TSW and AC-INLET cable, and fasten CNGD1
Connect the CNPFC cable to the POWER
UNIT BALLAT firmly until it clicks.
POWER UNIT
BALLAST
CNLAP
CNBAR
Put the ferrite FE1 of CNLAP near
its connector housing.
POWER UNIT CIRCUIT
Pass CNBAR here.
Pass CNLAP here.
Make sure to pass the CNBAR and the CNLAP
through respective holes of the BALLAST HOLDER
as shown in the picture before fixing the POWER
UNIT BALLAST. See the chapter 8 regarding how to
attach the POWER UNIT BALLAST.
Pass the CNPW and TSW cable through
this hole. Pay attention not to pinch the
CNPOW when assembling this block.
Fasten the CNGD1 to the power
supply block with a screw (T4x8).
NG
Wrong wiring:
The wires of CNPW are running at the opening.
The wires may touch the POWER FAN.
Wiring diagram 2
Pass the AC-INLET cable
through this hole.
Push these wires inside this block so that
they may not touch the POWER FAN
attached in later process.
Advertisement
Table of Contents
