Advertisement
Available languages
Available languages
4 INSTALL CUSTOM
ACCESS PANEL
• Place 1/4" custom panel in position on the
access panel assembly. Use masking tape to
hold in position.
• Loosely, install 3 color matched screws into
the bottom of the access panel.
• Peel paper backing off the tape on the
bottom trim piece.
• Slip trim under screw heads and press the
trim against the bottom of the access panel.
Tighten screws.
• Remove masking tape.
• Position top trim against the custom panel
and form the ends over the sides of the
panel.
• Remove the trim and peel off the paper
backing on the tape.
• Reinstall the trim over the assembly.
• Use masking tape to hold the trim against
the panel on each side.
• Drill holes
through the
side trim holes
and into the
access panel.
Secure each
side with one
screw.
• Remove
masking tape.
5 IINSTALL ACCESS PANEL
ASSEMBLY AND TOEKICK
• Place the toekick against the bottom of the
dishwasher.
• Place the access
panel assembly
against the dish-
washer and
tighten the at-
tached screws.
• Re-install two
original bottom
screws loosely.
Adjust the toekick
up or down and
tighten screws.
Pub. No. 31-30501-2
Tighten
2 Screws
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
INSTALLATION OPTIONS
This trim kit is designed to accommodate
1/4" thick panels. A raised panel screwed or
glued to 1/4" thick backing can be used.
The raised portion of the panel must be
fabricated to permit clearances for the trim
on all sides.
1/4" Min. Clearance
Appearance
1/4"
Panel
Thick
Panel
1/8" Min.
Clearance
X
Clearance
Access Panel
1/4" Min. Clearance
All Sides
29-9/16"
• "X" Clearance shown at the bottom of
the raised panel must be maintained to
prevent the door from striking the access
panel when opened.
Appearance
Panel
Backing
3/4"
1/4"
1/2"
1/4"
A 3/4" thick custom panel may be in-
stalled by routing the top and sides to 1/4"
thickness. The bottom edge, Dimension
"X", should be 1-1/2" high and 1/4" thick.
IMPORTANT!
GPF100 Dishwasher Door
Spring Kit MUST BE installed
when custom door panels
weigh 4 pounds or more.
1/8" Min.
Clearance
18-7/8"
23-9/16"
3-11/16"
Total
"X"
Thickness
Clearance
1"
2"
3/4"
1-7/8"
DWG. NO. 206C1559P037
N.D. 923-14 (3/04)
Advertisement
