Page 2
1.0 TECHNICAL SPECIFICATION VIDEO PERFORMANCE COMPONENT VIDEO RGB Test equipment:Audio Precision System2 Luminance amplitude output: 700mV ± 10% Test discs:CDDA: Philips audio signal test disc 1 RGB unbalance:5% DVD: Philips LVP 9.01 audio test disc Sync. Amplitude: 300mV ± 100mV Load Impedance:100KΩ...
Page 3
All manuals and user guides at all-guides.com 1.1 PCBs LOCATION DVD BOARD 8W/2P POWER BOARD DECK AMI POWER SW BOARD KEY BOARD USB BOARD VERSION VARIATIONS Type/Versions: DVP3100 Service policy Board in used: DVD BOARD 8W/2P POWER BOARD KEY BOARD USB BOARD POWER SW BOARD *TIPS: C -- Component Lever Repair.
Page 4
Select “0” setting = Region Free (confidential) Procedure for SW upgrade 1. The upgrade will provide a document re-named: PHILIPS.BIN “PHILIPS.BIN” copy to USB or CD-ROM into the data; 3. Reading the USB or CD-ROM,in accordance with prompt,press ”OK” key to upgrade.
Page 5
All manuals and user guides at all-guides.com 2.0 Safety instruction 1. General safety 2. Laser safety Safety regulations require that during a repair: This unit employs a laser. Only qualified service . Connect the unit to the mains via an isolation personnel transformer.
Page 6
All manuals and user guides at all-guides.com 3.0 INSTRUCTION FOR USE You can download this information from the following websites: http://www.philips.com/support...
Page 7
All manuals and user guides at all-guides.com 4.0 MECHANICAL AND DISMANTLING INSTRUCTIONS The following guidelines show how to dismantle the player. Step1: Remove 5 screws around the Top Cover, and then remove the Top Cover(Figure1) Figure 1 Step2:If the tray can’t open in normal way, you can make it through the instruction as below (Figure2) Figure 2 Step2: If it is necessary to dismantle Loader or Front Panel, the Front door should be removed first(Figure3) Figure 3...
Page 8
All manuals and user guides at all-guides.com 4.0 MECHANICAL AND DISMANTLING INSTRUCTIONS Step4: Remove the 10 screws on board to dismantle the DVD BOARD & POWER BOARD & LED BOARD (Figure 4&5) Figure4 Figure5...
Page 9
All manuals and user guides at all-guides.com Trouble shooting chart Spindle motor does not move Motor not move Check the FFC connection Correct connection between 24P and the loader. Check whether “MO_VCC” Check the MOVCC power (VCC) voltage is normal. supply Check whether laser voltage Check/Replace Q10 Q11.
Page 10
All manuals and user guides at all-guides.com Trouble shooting chart The power can not be on or off The power can’t be on or off Check the power supply Replace the power board on the power board and the connection to or correct the connection to decoder board is normal.
Page 11
All manuals and user guides at all-guides.com Trouble shooting chart Disc cannot be read . Disc cannot be read. Check the FFC connection Check the loaded circuit between 24P and the loader. 1.Check voltage on pin 23 of U2 varies between 0 and 3.3V: Check whether there is 3.3V for CD laser voltage (1.9V for CD...
Page 12
All manuals and user guides at all-guides.com Trouble shooting chart Only DVD disc or only disc except DVD can be played Only DVD disc, or only disc except DVD can be Played. Check Check the loaded circuit connection between 24pin and the loader. Check laser voltage (1.9V) output on Collector of Q11, if Check the solder status on U2 and...
Page 13
All manuals and user guides at all-guides.com Trouble shooting chart Distorted audio and loud noise Distorted audio and loud noise Check he power supply voltages +12V Replace L2 to the operation amplifying L2 are normal Check whether Replace Q12, Q14 muting transistors Q12, Q14, are normal Checking the U2 leads...
Page 14
All manuals and user guides at all-guides.com Trouble shooting chart Abnormal color of video picture Abnormal color of video picture Check whether the 27MHz Check Y1, R17, C21 and C22 output signal is normal. Check whether the 3.3V Check other of power supply electric and 1.8V power supply circuit voltages on the decoder...
Page 15
All manuals and user guides at all-guides.com Trouble shooting chart Remote reception is insensitive or fails. Remote reception is insensitive or fails. Check if the remote Check battery control works properly. Check power Check R1 R2 on front board supply voltage to the remote censor is normal Use an oscilloscope to check if there is output waveform...
Page 16
All manuals and user guides at all-guides.com Trouble shooting chart No video picture, no sound. No video picture, no sound. Check whether voltages from the power Check the loaded circuit board to the decoder board are normal. CVBS(L27 point) waveform Check if the reset circuit consisting of C13, Q4, Q3,R11,R12,R13,R15,R16 is normal Change C13,Q4,Q3...
Page 17
All manuals and user guides at all-guides.com Trouble shooting chart No display on LED, and buttons do not work LED and buttons do not work Check whether there is correct contact Correct connection between CON1 of front board and J 6 of decoder board Check DV33(+3.3V) Fix power supply board top...
Page 18
All manuals and user guides at all-guides.com WIRING DIAGRAM SDRAM 3.3V AV-OUT RCA 1*16&4*16 1.8V 3.3V 1.8V ASA 8829B+Sanyo DV38 4558 DVD-CVBS ASA 8829B+ DVD-AU-R DVD-AU-L Sanyo DV38 Y&U&V RCA MT1389L COAX AM5888S SENSOR Flash 8M&16M...
Page 19
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM- MAIN BOARD +12V +12V [2,4] POWER PART [2,4] DV33 DV33 [2,3,4,5] 4.3K/1%/5.1K 89L_3V3 89L_3V3 FB18 8550 + CE1 10K/1% 220uF/6.3v 0.1uF URST# URST# POWER I/F 5.6dip TROUT TROUT +P12V OUT18 TRIN +P12V TRIN TROUT...
Page 20
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - MAIN BOARD 89L_3V3 89L_3V3 MCU PART L12 FB600R ADACVDD DQ[0..15] DQ[0..15] RFV18-1 0.1uF 89L_3V3 RFVDD3 MA[0..11] DACVDD3 DACVDD3 MA[0..11] 0.1uF DQM[0..1] 100uF/10v + CE9 DQM[0..1] 0.1uF BA[0..1] 0.1uF 0.1uF 10uF/10v BA[0..1] 100k DCLK...
Page 21
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - MAIN BOARD DQ[0..15] DQ[0..15] MA[0..11] SDRAM & FLASH PART MA[0..11] DQM[0..1] DQM[0..1] BA[0..1] BA[0..1] DCLK DCLK RAS# RAS# CAS# CAS# SD33 DRAM I/F SD33 + CE19 SDCKE 100uF/10v 0.1uF 0.1uF 0.1uF SF_CK SF_CK...
Page 22
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - MAIN BOARD AUDIO PART AUDIO I/F 100pF AKIN AKIN 5.1k AUDIO_MUTE EC21 AUDIO_MUTE 2 10uF/16V NJM4558 +12V +12V 10uF/25V 4700pF 3300pF A_MUTE 100k 2N3904 +12V DV33 DV33 1,2,3,4,5 AVCC AVCC AVCC 1,2,4,5 2N3906/NC...
Page 23
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - MAIN BOARD CVBS_OUT CVBS_OUT VIDEO PART ASPDIF ASPDIF VIDEO_EN VIDEO_EN VB_5V ASPDIF COAXIAL VIDEO I/F 0.1uF 75,1%/NC R/V_OUT 330pF AUDIO I/F L24 1.8uH 2N3906/NC DV33 DV33 [1,2,3,4] AVCC AVCC [1,2,4,5] +12V +12V [1,5]...
Page 24
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - FRONT BOARD LED LIGHT & IR 3.3V 100R REM301 IRVCC 3.3V R5 4.7K 3.3V LED1 100R KS1 OPEN/CLOSE CE1 4.7UF/6.3V 100pF POWER ON 120R 120R 2N3904 2N3904 Play/Pause 3.3V LED+ LED- DATA R6 4.7K...
Page 25
All manuals and user guides at all-guides.com CIRCUIT DIAGRAM - STB/POWER BOARD STB/POWER PART CON4 4x1 W/HOUSING LED3 POWER OFF Standby/Power...
Page 26
All manuals and user guides at all-guides.com MAIN BOARD TOP...
Page 27
All manuals and user guides at all-guides.com MAIN BOARD BOTTOM...
Page 28
All manuals and user guides at all-guides.com 7-10 LED LIGHT BOARD TOP PCB COMPONENT LAYOUT...
Page 29
All manuals and user guides at all-guides.com 7-11 LED LIGHT BOARD BOTTOM PCB COMPONENT LAYOUT...
Page 30
All manuals and user guides at all-guides.com 7-12 STB TOP PCB-COMPONENT LAYOUT...
Page 31
All manuals and user guides at all-guides.com 7-13 STB BOT PCB-COMPONENT LAYOUT...
Page 32
All manuals and user guides at all-guides.com 8.0 Exploded View Diagram...
Page 33
DVD LOADER RT628 CBU RELY DVP3100/98/79/96 Accessories parts list 12NC No. Part Name CARADP 996510029219 AC CORD VDE 12DETCHBLE 1.3M XIEJIN DVP3100/98 CARADP 996510029037 AC CORD CT 79FIXED 1.3M XIEJIN DVP3100/79 ACCORD 996510029658 AC CORD UL 37FIXED 1.3M XIEJIN DVP3100/96...
Page 34
All manuals and user guides at all-guides.com 9.0 REVISION LIST Version 1.0 • Initial release Version 1.1 • Version 1.2 • • Modification spare part list...