Supply Air/Exhaust Air; Steam Connection (Only For Steam-Heated Variants); Hot Water Connection (Only For Hot Water-Heated Variants); Gas Connection (Only For Gas-Heated Variants) - Miele PDR 914 Operating And Installation Instructions
Commercial tumble dryers
Hide thumbs
Also See for PDR 914:
- Quick start manual (144 pages) ,
- Operating and installation instructions (80 pages) ,
- Quick start manual (140 pages)
Table of Contents
Advertisement
Installation
34
Supply air/exhaust air
The tumble dryer may only be operated when the ducting has been
connected properly and the room is sufficiently ventilated.
Steam connection (only for steam-heated variants)
The steam connection must only be carried out by an authorized in-
stallation technician. The enclosed installation instructions must be
observed as they are important for the steam connection.
Hot water connection (only for hot water-heated vari-
ants)
The hot water connection may only be carried out by an authorized
installation technician.
The enclosed installation instructions must be observed as they are
important for the hot water connection.
If a faucet is desired, it must be installed on site.
Gas connection (only for gas-heated variants)
The gas connection must only be carried out by an authorized instal-
lation technician in accordance with the applicable national regula-
tions (see installation instructions).
The use of a gas socket is not permitted at the specified heater rating
as the flow rate is too low.
The gas heating is configured at the factory in line with the gas speci-
fications on the sticker on the rear of the machine.
If the gas family is changed, a conversion kit must be requested from
Miele Service (please specify the machine type, serial number, gas
family, gas group, gas connection pressure, and country of installa-
tion). Follow the installation instructions. This conversion may only be
carried out by an authorized specialist.
Risk of electric shock and injury due to using the tumble dryer
without the complete casing.
If the casing is dismantled, it is possible to come into contact with
live or rotating machine parts.
Once the tumble dryer has been installed, completely replace all
the casing parts that were removed.
Advertisement
Table of Contents
